Submersible pumps may be vertical or horizontal type. Each type is designed to be installed for a closed and open well system. If the pump has been running consistently, then it may fail very often. Quick fix checks can be performed, to ensure it keeps running.
- You need to configure the Openwell Horizontal Pump depending on the depth and pumping distance factor.
- Regular maintenance can eliminate the need for a quick fix in case of failures.
- Always ensure you maintain a troubleshooting guidebook along with your handy.
So, in general, there are a few troubleshoots, then can happen most often, and needs to be rectified immediately, so the keeps running.
Idle motors
You switch-on the motor and it does not run! This is one of the most common issues faced by many. Openwell Horizontal Pump can get overheated when running non-stop for hours. So there are chances that the central axle gets jammed.
This happens in most cases, in pumps that are not greased very often. Also, check with the trip breaking switch if this happens.
Over-running motor
Overusing the pump can also force liquid to leak out from one or more points. This can get serious if it has not been rectified on time. In most cases, using sealant proves beneficial. Always ensure that for Openwell Horizontal Pump you only use industrial-grade sealant.
Check with faulty pressure as high pressure can also force the liquid to leak from certain points.
Common trips
In most cases, if you have connected a tripping switch across the circuit, then trips are very often. In most cases, this happens if the pumps face over-load issues. Check for input and output pressure in this case. If possible adjust normal pressure for liquid.
Apart from this, if the submersible pump is well maintained, then you may not need to check with them, even if left functional for hours. These are heavy-duty pumps and need less maintenance.
No comments:
Post a Comment