Submersible pumps may
be vertical or horizontal type. Each type is designed to be installed for a
closed and open well system. If the pump has been running consistently, then it
may fail very often. Quick fix checks can be performed, to ensure it keeps
running.
- You need to configure the Openwell
Horizontal Pump depending on the depth and
pumping distance factor.
- Regular maintenance can
eliminate the need for a quick fix in case of failures.
- Always ensure you maintain a
troubleshooting guidebook along with your handy.
So, in general, there
are a few troubleshoots, then can happen most often, and needs to be rectified
immediately, so the keeps running.
Idle motors
You switch-on the
motor and it does not run! This is one of the most common issues faced by
many. Openwell
Horizontal Pump can get overheated when
running non-stop for hours. So there are chances that the central axle gets
jammed.
This happens in most
cases, in pumps that are not greased very often. Also, check with the trip
breaking switch if this happens.
Over-running motor
Overusing the pump can
also force liquid to leak out from one or more points. This can get serious if
it has not been rectified on time. In most cases, using sealant proves
beneficial. Always ensure that for Openwell Horizontal Pump you only
use industrial-grade sealant.
Check with faulty
pressure as high pressure can also force the liquid to leak from certain
points.
Common trips
In most cases, if you
have connected a tripping switch across the circuit, then trips are very often.
In most cases, this happens if the pumps face over-load issues. Check for input
and output pressure in this case. If possible adjust normal pressure for
liquid.
Apart from this, if
the submersible pump is well maintained, then you may not need to check with
them, even if left functional for hours. These are heavy-duty pumps and need
less maintenance.
https://unnatipumps.com/openwell-horizontal-pump
No comments:
Post a Comment